LED installations by STRIDE — Instructions & Disclaimer

This page describes what STRIDE provides as standard with a LED installation, what it does not, and what preparations your electrician must make in the case of central control or complex projects.

What STRIDE provides as standard

• Connection to a 230V socket, at a maximum distance of 2 metres from the light source (LED strip, frame or logo).
• The adapter (transformer) and controller are placed visibly and neatly finished, e.g. on the floor, against a wall or against the ceiling.
• 24V LED strips. Each individual line may be a maximum of 10 metres long due to voltage drop.
• Cables are, if necessary, concealed in surface-mounted cable trunking. These remain visible.
• For simple installations (maximum 3 LED lines), STRIDE provides the control via the free Tuya app (wifi controllers) or an RF remote control.
• STRIDE installs 3 types of LED profiles: All-purpose profile 20x20 mm (glue-mount only), Step-on floor profile (glue-mount only) and Large profile 30x40 mm (glue-mount or suspended with pendant cables).

What STRIDE does not provide

• No modifications in the electrical cabinet — our installers do not work on or in electrical cabinets.
• No concealment or hiding of the adapter/controller behind walls, in ceilings, floors or technical rooms.
• No home automation integration or central control systems (unless fully prepared by an electrician).
• No cable runs longer than 2 metres from the light source.
• No aesthetic finishing such as casing, cover panels or structural finishing.
• No wiring for complex projects (see below).

Instructions for the customer and/or their electrician

When central control or a pre-planned connection is chosen, the following requirements apply:

• The electrician provides 2-core cables (1.5 mm², 24V) to the correct location, according to plan.
• These cables must be switchable to ensure a safe installation.
• All preparatory electrical work must be completed before the arrival of the STRIDE installers.
• If desired, STRIDE can send adapters in advance, so that the electrician can install them in the technical room.
• The electrician may provide transformers on DIN-rail if desired.
• A junction box must always be provided for connections (surface-mounted or recessed). For floor cabling (such as LED next to Sprinttracks), this must be embedded in the floor. A minimum of 5 cm x 5 cm of space is needed to conceal cables and contact points (such as Wago connectors).

Technical specifications LED strips

Complex LED installations — collaboration required

For projects with multiple LED lines, central control or integration into home automation, the following applies:

• Based on visuals or plans, STRIDE can indicate where cabling should go, but does not provide it itself.
• The complete control and electrical cabling must be provided by the electrician.
• Responsibility for the operation and safety of the control lies with the electrician.
• STRIDE does mount all LED strips, frames and profiles, provided that the cables are correctly in place.
• For complex projects, the installation hours can only be estimated approximately.
• For each connection location, a junction box (5x5 cm) must be provided, with sufficient space for cables and connectors.